Warning about fraudulent Online Sites claiming to offer Faber-Castell products. More information

Design your own Mother´s Day breakfast jar and the matching gift paper

Breakfast jar

Step 1

Decide which area of the jar you want to paint. A small hint from our side: The less curvy the jar, the easier it is to decorate.

Before getting started on your glass, you should design the lettering on a piece of paper. Sketch a rectangle in the size of your desired letter design on paper and mark the middle for orientation. Add additional supporting lines for each row that you want to write in. This helps your letters to be equal in size and the words to be on the same level.

Step 2

Place your lettering inside the prepared rectangle. Start lettering on paper using pencils, in order to define and test your color schemes and to see whether the sketch fits the line width of pens. Once you are done with your sketch, cut out the lettering and tape it on the jar using washi tape. This will be your drawing template.
 

Step 3

Once you are done with your sketch, cut out the lettering and tape it on the jar using washi tape. This will be your drawing template.
Make sure that the surface is clean and free of dust before you start lettering on the jar. To make writing on a 3D surface easier you can stabilize your arm by creating an armrest next to the vase using books or magazines, etc.

In case of a typo wipe the ink off the jar and restart. The ink will be dry and wipe-proof after 24 hours, which allows you plenty of time for alterations.

Wrapping paper

Step 1

Take a sheet of paper to sketch the lettering first. Start by drawing the lines in between which you want to place the word “Mom”.

Step 2

Start sketching the letters one by one on the defined lines. If the wrapping paper is transparent enough, you can trace your preliminary sketch on the wrapping paper and copy your writing. Use a pencil for the tracing and the Pitt Artist Pens to finalize your lettering using different stroke widths. If you want to transfer the lettering to a non-transparent wrapping paper, crosshatch your sketch on the back using a soft pencil, place your sketch on the present (the backside facing down) and trace the lines of the letters with your pencil. By doing so, the pencil lines will be transferred onto the wrapping paper. Finalize your lettering with Pitt Artist Pens using different stroke widths.

Step 3

To create a golden 3D effect, add lines to indicate shadows next to your letters. The source of light in our example is at the top left. Therefore, the golden shadows should be drawn off-centered to the bottom right of the letters. To complete the Lettering, you can add highlights to the letters on the top left, the side that the light comes from.